Separating a mixture of solids

• Differences in solubility can be used to separate solids

• For a difference in solubility, a suitable solvent must be carefully chosen

  • Only the desired substance should dissolve in the solvent

  • Other substances or impurities in the mixture should not dissolve in the solvent

• For example, to separate a mixture of sand and salt:

  • Water is a suitable solvent because salt is soluble in water, but sand is insoluble in water

Filtration

• This technique is used to separate an undissolved solid from a mixture of the solid and a liquid / solution ( e.g. sand from a mixture of sand and water)

  • Centrifugation can also be used for this mixture

• A filter paper is placed in a filter funnel above another beaker

• The mixture of insoluble solid and liquid is poured into the filter funnel

• The filter paper will only allow small liquid particles to pass through in the filtrate

• Solid particles are too large to pass through the filter paper so will stay behind as a residue

Crystallisation

• This method is used to separate a dissolved solid from a solution

  • A simple application of this is to heat a solution to boiling, remove the heat and leave the solvent to evaporate

• A more common application of this is sometimes called crystallisation 

  • This is when the solid is more soluble in hot solvent than in cold, e.g. copper sulphate from a solution of copper(II) sulphate

• The solution is heated, allowing the solvent to evaporate and leaving a saturated solution behind

• You can test if the solution is saturated by dipping a clean, dry, cold glass rod into the solution

  • If the solution is saturated, crystals will form on the glass rod when it is removed and allowed to cool

• The saturated solution is allowed to cool slowly

  • Solids will come out of the solution as the solubility decreases

  • This will be seen as crystals growing

• The crystals are collected by filtration

• They are then washed with distilled water to remove any impurities

• Finally, they are allowed to dry

  • Common places to dry crystals are between sheets of filter paper or in a drying oven

    
    

Simple distillation

• Distillation is used to separate a liquid and soluble solid from a solution (e.g. water from a solution of saltwater) or a pure liquid from a mixture of liquids

• The solution is heated and pure water evaporates producing a vapour which rises through the neck of the round-bottomed flask

• The vapour passes through the condenser, where it cools and condenses, turning into pure water which is collected in a beaker

• After all the water is evaporated from the solution, only the solid solute will be left behind

• Simple distillation can be used to separate the products of fermentation, such as alcohol and water

• However, fractional distillation is a more effective separation technique, commonly used when the boiling points of the liquids are close and/or a higher degree of purity is required, such as crude oil

Fractional distillation

• Used to separate two or more liquids that are miscible with one another (e.g. ethanol and water from a mixture of the two)

• The solution is heated to the temperature of the substance with the lowest boiling point

  • This substance will rise and evaporate first

  • The vapours will pass through a condenser, where they cool and condense

  • The condensed liquid is then collected in a beaker

  • All of the substance is evaporated and collected, leaving behind the other component(s) of the mixture

• For water and ethanol:

  • Ethanol has a boiling point of 78 ºC

  • Water has a boiling point of of 100 ºC

  • The mixture is heated until it reaches 78 ºC, at which point the ethanol distills out of the mixture and into the beaker

  • When the temperature starts to increase to 100 ºC heating should be stopped as the water and ethanol are now separated

• An electric heater is safer to use when there are flammable liquids present

• The separation of the components in petroleum is achieved by fractional distillation on an industrial scale

• Fractional distillation of crude oil is not carried out in school laboratories due to the toxic nature of some of the components of the crude oil, but it can sometimes be simulated using a synthetic crude oil made specially for the demonstration